Know About Aluminum Bending Techniques

Aluminum is a very flexible and useful metal. This finds use in many places in our daily lives. It is used for packaging, transportation, electricity industry and many other uses every day.

No other metal has found as much use as aluminum. Aluminum is also used for making glass. Bending aluminum can be a little boring. Some useful aluminum bending techniques are:

Buy aluminum sheets to match the color of use you need. Take a sheet that is slightly larger than the place to be used because some areas may be reduced by bending.

Check with local hardware stores to find brakes that can be rented. With the help of the brakes, you can bend aluminum uniformly and quickly. This will save a lot of time for large projects.

Know about if brakes are not available, and then get a combination box so you get a sturdy edge that can be used to bend aluminum manually. Pipe, Tube Bending & Rolling Service provides a wide array of performance- and safety-tested options to fit your business’s needs.

Image result for aluminum bending techniques

At a small distance from the short edge, use your combination box or brake as a straight edge and cut the sheet using a knife or utility knife. The cut should be deep enough to allow bending but not to break.

Bend your aluminum sheet up to ninety degrees along your cut. This surface must function as the bottom to secure the sheet to the places needed.

Cut small marks on the sheet using a knife to mark the place where the sheet must be bent. Along this mark, make forty-five degrees of the incision in your lower crease.

Keep the combination square at ninety degrees to the long side of your sheet. Make sure the surface is flat. Hold it at the bottom of the sheet.

Place one of your hands under the sheet and the other to hold the combination box in place. Push gently up to bend the aluminum sheet at the angle you need for your job. It is recommended to undershoot the bend and then shape your sheet according to your needs.

Do not buy brakes unless there are plans for other home repairs that require aluminum bending or other metal bending. Brakes are quite expensive and not worth investing in if you only need them for one small job.

Leave a Reply